LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Brake System - Mechanical Components) >> 46 Mechanical Components >> Front Brakes, Ceramic, Pr-1LN/1LW >> Brake Caliper, Removing And Installing >> Installing

Brake Caliper, Removing And Installing : Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Do not loosen the bolted connections -A arrows-

Fig 1: Do Not Loosen The Bolted Connections
GWWA46-10354Courtesy of AUDI OF AMERICA, LLC

Tighten the guide pins -B arrows- to 21 Nm to 26 Nm.

WARNING:

There is a risk of malfunction.

  • Do not loosen the bolted connections -A arrows-
  • Tighten the guide pins -B arrows- to 21 Nm to 26 Nm.
WARNING: Do not blow out the brake caliper with compressed air.
NOTE:

Replace the brake caliper bolts.

Use only mineral spirits or commercially available brake cleaner to clean the brake caliper.

-- Clean the brake caliper.

-- Slide the brake caliper with the brake pads installed carefully over the brake rotor.

-- Tighten the new bolts -1-.

Fig 2: Identifying Bolts
GWWA46-10192Courtesy of AUDI OF AMERICA, LLC

-- Secure the brake hose -3- to the bracket.

Fig 3: Identifying Connector And Tab
GWWA46-10300Courtesy of AUDI OF AMERICA, LLC

-- Bring the connector -2- into its installed position and turn in direction of the -arrow- until the tab -4- engages in the hole -5- on the bracket.

-- Connect the connector -1-.

NOTE:

Make sure that the connector and brake hose are routed correctly.

Make sure the brake hose is not blocked, bent or rubbing against the vehicle.

-- Install the front wheel while observing the safety precautions for vehicles with ceramic brakes. Refer to Wheels, Tires, Wheel Alignment .

WARNING:

Make sure the brakes are working correctly before driving the vehicle for the first time.

After installing, press the brake pedal several times firmly to properly seat brake pads in their normal operating position.

Check brake fluid level, and fill if necessary.