Brake Pedal, Removing And Installing, With Manual Transmission

Special tools and workshop equipment required 

• Torque Wrench 1410 VAG 1410

To remove the brake pedal on vehicles with a manual transmission, the mounting bracket must be removed.

-- Remove the mounting bracket. Refer to Removing .

Remove the brake pedal on the removed mounting bracket.

-- Remove the bolt -3-.

Fig 1: Brake Pedal, Removing And Installing Overview

Courtesy of AUDI OF AMERICA, LLC

-- Remove the retainer -1- on the left side and remove the pins -5- to the right.

Fig 2: Brake Pedal, Removing And Installing Overview

Courtesy of AUDI OF AMERICA, LLC

-- Remove brake pedal.

Install the brake pedal on the removed mounting bracket.

Fig 3: Brake Pedal Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

-- Slide the right retainer onto the pins.

-- Slide the pins from right to left through the axle in the brake pedal.

-- Secure the pins with the left retainer -1-.

Fig 4: Brake Pedal, Removing And Installing Overview

Courtesy of AUDI OF AMERICA, LLC

The pins must be secured with the retainers on both sides.

-- Install and tighten the bolt -3-.

Fig 5: Brake Pedal, Removing And Installing Overview

Courtesy of AUDI OF AMERICA, LLC

-- Install the mounting bracket. Refer to Installing .

Check the function of the Brake Lamp Switch -F- after installing it and before driving the vehicle.