Bracket, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the plenum chamber cover. Refer to Body Front .

-- Remove the tower brace -1- at the bolts -2 through 4-.

Fig 1: Identifying Tower Brace And Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connectors from the engine control module and move them to the side.

-- Remove the bolts -8- from the brake booster bracket.

Fig 2: Overview Of Brake Booster/Master Brake Cylinder

Courtesy of AUDI OF AMERICA, LLC

-- Move the seat all the way back as far as it will go.

-- Turn off the ignition.

-- Remove the instrument panel cover on the driver side. Refer to Interior Equipment .

-- Remove the footwell vent.

-- Disconnect the connector to the Brake Lamp Switch -F-.

-- Remove the Brake Lamp Switch -F- -8-. Refer to Brake Lamp Switch -F-, REMOVING AND INSTALLING .

Fig 3: Identifying Mounting Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -15-.

-- Disconnect the connector from the accelerator pedal module -6-.

-- Remove the steering column. Refer to Steering .

-- Remove the bracket, with the brake pedal still installed, from the vehicle.

NOTE: Remove both clips -1-.

-- Remove both locking springs -1- from the bolt -5-.

Fig 4: Brake Pedal, Removing And Installing Overview

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the bolt -3-.

-- Remove the bolt -5- from the brake pedal -2- and bracket -4-.

-- Remove the brake pedal from the bracket.

WARNING: If possible, leave the brake pedal stop installed; it could break the mount for the Brake Lamp Switch -F- if the brake pedal is released too quickly.

-- Remove the accelerator pedal module.