Backrest Fan, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Fan Upper Backrest

Courtesy of AUDI OF AMERICA, LLC

Standard Seat/Sport Seat/Super Sport Seat:

-- Remove the backrest cover. Refer to Removing .

Upper fan:

-- Free up the connector -1- and disconnect.

-- Carefully pry the backrest fan -2- out of the backrest cushion using the Trim Removal Wedge 3409 -arrow-.

Lower fan:

Fig 2: Identifying Slider -1-

Courtesy of AUDI OF AMERICA, LLC

-- Adjust the lumbar support to the highest curve while moving the slider -1- all the way down -arrow A-.

NOTE:

Ignore -item 2-.

-- Disconnect and free up the connector -1-.

Fig 3: Backrest Fan -2- Connector -1-

Courtesy of AUDI OF AMERICA, LLC

-- Carefully pry the backrest fan -2- out of the backrest cushion using the Trim Removal Wedge 3409 -arrow-.

Multi-Contour Seat:

Fig 4: Disconnect The Connector -2- Spray The Rubber Protrusions

Courtesy of AUDI OF AMERICA, LLC

-- Remove the backrest cover. Refer to Removing and Removing .

-- Disconnect the connector -2- and free it up.

-- Spray the rubber protrusions -arrows- of the elastic blower fan mount -1- with silicon-free lubricating spray.

-- Detach blower fan from the rubber protrusions and remove it.