Backrest Cover, Removing And Installing, MULTICONTOUR Seat Without Optional Equipment: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Move Front Seat Forward/Up

Courtesy of AUDI OF AMERICA, LLC

-- Move the front seat all the way forward/up.

NOTE:

The clips -1- and -2- together with hooks on the backrest frame can only be detached up to the first catch.

-- Release the clips -1- and -2- up to the first retainer -A arrows- using the Pry Lever 80 - 200.

-- To disengage the clips -1- with the hooks, move the backrest cover -3- in direction of -arrow C-. The clips will slide out of the guide on the backrest cover.

-- Then, to disengage the clips -2- with the hooks, move the backrest cover in direction of -arrow B-. The clips will slide out of the guide on the backrest cover.

-- Pull the backrest cover -1- in the upper section as far as possible toward the rear from the backrest -arrow-.

Fig 2: Release Clips -1- And -2

Courtesy of AUDI OF AMERICA, LLC

-- Press down and remove the backrest cover hooks -2- with a large flat blade screwdriver from the backrest frame.

NOTE:

Use a flashlight and mirror if necessary.

-- Detach left and right rubber strap -1- at the bottom of the seat pan.

Fig 3: Disconnecting Lower Left And Right Rubber Straps An Seat Pan

Courtesy of AUDI OF AMERICA, LLC

-- Pull off backrest cover in upward direction.