Massage Mat Valve Block, Removing And Installing, KONGSBERG MULTICONTOUR Seat: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the backrest cover. Refer to Removing and Removing .

NOTE:

If a repair is required, the pneumatic line from the compressor is not disconnected at the connection, but is disconnected by the described procedure. Refer to PNEUMATIC LINES, DISCONNECTING AND CONNECTING .

Driver Side:

Fig 1: Disconnect The Pneumatic Line

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the pneumatic line -1- from the compressor at the following locations:

a -30 mm

Front Passenger Side:

Fig 2: Disconnect The Pneumatic Line

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the pneumatic line -1- from the compressor at the following locations:

a -315 mm

Continued for Both Sides:

Fig 3: Connector, Pneumatic Lines, Release Ring & Valve Block

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -6-.

-- Before disconnecting, mark the pneumatic line assignments to the connections at the valve block using a waterproof permanent marker.

-- Disconnect the pneumatic lines -1 through 5- from all of the massage mat air cushions.

-- To do this, press the release ring -2- in the direction of the valve block -1- -arrow A- and at the same time pull out the pneumatic line -3- -arrow B-.

Fig 4: Release Ring, Valve Block & Pneumatic Line

Courtesy of AUDI OF AMERICA, LLC

-- Pull the rubber buffer lengthwise -arrow A-.

Fig 5: Rubber Buffer & Valve Block

Courtesy of AUDI OF AMERICA, LLC

-- Remove the valve block from the rubber buffer -arrow B- simultaneously.