LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Seat Frames) >> 72 Seat Frames >> Front Seat Pneumatic System >> MULTICONTOUR Seat Valve Block, Removing And Installing >> Massage Mat Valve Block, Removing And Installing, H O RBIGER MULTICONTOUR Seat >> Removing

Massage Mat Valve Block, Removing And Installing, H O RBIGER MULTICONTOUR Seat: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Connector, Massage Mat Valve Block & Pneumatic Lines
GWWA72-11170Courtesy of AUDI OF AMERICA, LLC

-- Remove the backrest cover. Refer to Removing  and Removing .

-- Disconnect the connector -3-.

-- Push massage mat valve block -4- up slightly to detach it at the module carrier -arrow A-.

-- Carefully release locking mechanism -arrow B-, disconnect pneumatic lines -1- and -2-.

-- Disconnect pneumatic lines to the massage mat air cushions at the following points (refer to PNEUMATIC LINES, DISCONNECTING AND CONNECTING ):

Fig 2: Disconnect Pneumatic Lines
GWWA72-11251Courtesy of AUDI OF AMERICA, LLC

a - 40 mm

scientia non olet · About LEMON Manuals