Front MULTICONTOUR Seat Control Module, Removing And Installing, H O RBIGER MULTICONTOUR Seat: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the backrest cover. Refer to Removing and Removing .

-- For reinstallation, mark pneumatic lines at the separating point with a waterproof permanent marker.

NOTE:

Original replacement parts have an integrated check valve and restrictor and the connection for the restrictor has been removed.

Remove the external check valve if installing a multicontour seat control module that contains a check valve.

Original replacement parts are delivered with short sections of line to which pneumatic lines with line connectors are connected.

Before disconnecting the pneumatic lines, transfer the length of the sections of line from the original spare part to the part to be removed and disconnect at exactly this point.

-- Disconnect the connector -5-.

Fig 1: Connector, Pneumatic Line, Front Seat Control Module & Pneumatic Lines

Courtesy of AUDI OF AMERICA, LLC

-- Version with separate check valve: Disconnect pneumatic line on the check valve -1-, refer to CHECK VALVE, REMOVING AND INSTALLING .

-- Version with integrated check valve: disconnect the pneumatic line. Refer to PNEUMATIC LINES, DISCONNECTING AND CONNECTING .

-- Push the multicontour front seat control module -3- up -arrow- and remove it.

-- Disconnect the pneumatic lines -2 and 4- at the multi-contour front seat control module. Refer to PNEUMATIC LINES, DISCONNECTING AND CONNECTING .