Molded Foam Piece Mount, Removing And Installing, Audi RS7: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Molded Foam Part Mount

Courtesy of AUDI OF AMERICA, LLC

-- Remove the license plate.

-- Remove screws -2- and -3- on the license plate holder -1-.

-- Remove the molded foam part. Refer to Removing .

-- Remove the bolts -arrows-.

Fig 2: Removing Mount

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the center reinforcement brace just enough so that the mount can be removed downward. Refer to Removing .

-- Remove the mount -1-.