Overview - Final Drive: Notes
WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
- Flywheel
- Removing and installing. Refer to FLYWHEEL, REMOVING AND INSTALLING .
- Shaft Seal
- For the left flange shaft
- Between the final drive and the transmission housing
- Replacing. Refer to LEFT SEAL, REPLACING .
- Shim
- Behind the taper roller bearing outer race
- Taper Roller Bearing Outer Race
- Differential
- Bolt
- Quantity 10
- Tightening specification and sequence. Refer to Tightening Specification And Sequence, Front Final Drive Cover .
- Locking Ring
- Replacing
- Right Flange Shaft
- Removing and installing. Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING .
- Shaft Seal
- For the right flange shaft
- Replacing. Refer to RIGHT SEAL, REPLACING .
- Front Final Drive Cover
- Removing and installing. Refer to LEFT SEAL, REPLACING .
- O-Ring
- On the front final drive cover
- Replacing
- Shim
- Behind the taper roller bearing outer race
- Taper Roller Bearing Outer Race
- Spring Pin
- Gearshift Lever
- Shaft Seal
- For the selector shaft
- Replacing. Refer to SELECTOR SHAFT SEAL, REPLACING
- Bolt
- 10 Nm + 45°
- Quantity: 3
- Left Flange Shaft
- Removing and installing. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .
- Bracket
- Attached to the left flange shaft with the ball bearing -20- and the circlip -21-
- Check for traces of wear on the bearing bracket and check the pre-tension on the ball bearing for the left flange shaft. Refer to LEFT FLANGE SHAFT BALL BEARING PRE-TENSION, CHECKING AND ADJUSTING
- Ball Bearing
- For the left flange shaft
- Left Flange Shaft Ball Bearing Pre-Tension, Checking. Refer to LEFT FLANGE SHAFT BALL BEARING PRE-TENSION, CHECKING AND ADJUSTING
- Replacing. Refer to LEFT FLANGE SHAFT BALL BEARING MOUNTING BRACKET, REMOVING AND INSTALLING .
- Locking Ring
- For the left flange shaft bearing
- Replacing
- Shaft Seal
- For the input shaft
- Replacing. Refer to INPUT SHAFT SEAL, REPLACING .