Left Flange Shaft Ball Bearing Mounting Bracket, Removing And Installing
WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Press Plate :VW401
- Press Plate :VW402
- Press Piece - Multiple Use :VW412
- Press Piece - 42mm :VW516
-- Remove the left flange shaft. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .
-- Remove the locking ring -1- from the flange shaft.
-- Remove the ball bearing -A- from the flange shaft
-- Install the new bearing bracket -1-.
- Installed position: The printed side faces the drive axle flange.
-- Install the new ball bearing -2-.
-- Install the ball bearing -A- all the way on with the bearing bracket -B- installed.
-- Install the circlip -1- in the flange shaft groove.