Transmission Fluid, Draining And Filling
Special tools and workshop equipment required
- Adapter For Oil Filling: VAS6262A
- Used Oil Collection and Extraction Unit: SMN372500
- Original transmission fluid for the S tronic transmission 0D9. For the part number. Refer to the Parts Information.
- Protective eyewear
- Acid-resistant safety gloves
Procedure
Observe general notes. Refer to GENERAL INFORMATION .
Follow the rules for clean working conditions. Refer to CLEAN WORKING CONDITIONS .
Follow all disposal regulations for transmission fluids. Refer to GENERAL REPAIR INFORMATION .
Danger of personal injury.
- The coolant fan can come on by itself, even when the ignition is turned off, for example, caused by heat build-up inside the engine compartment.
- Wear protective eyewear.
- Wear acid-resistant safety gloves.
Danger of causing damage to the transmission.
- Do not start the engine if there is little or no oil in the transmission due to repair work or severe loss of transmission fluid.
- In this case, fill first with S tronic transmission fluid.
Conditions
- Move the vehicle onto a 4-column shop hoist or over a work pit so it is completely level.
- Selector lever in "P".
- The parking brake button should be activated to close the electro-mechanical parking brake.
- The engine is off.
- Remove the noise insulation -1-. Refer to NOISE INSULATION, REMOVING AND INSTALLING .
- The transmission fluid filter must always be replaced when changing the transmission fluid.
All safety precautions, notes and test requirements must be observed. Refer to TRANSMISSION FLUID LEVEL, CHECKING .
Transmission Fluid, Draining
-- Replace the transmission oil filter. Refer to TRANSMISSION FLUID FILTER, REMOVING AND INSTALLING .
-- Place the : SMN372500 under the transmission.
-- Remove the drain and check plug -A-.
-- Remove the overflow pipe -C- from the opening on the drain and check plug.
-- Drain any remaining transmission fluid.
-- Reinstall the overflow pipe.
Transmission Fluid, Filling
Danger of causing damage to the transmission.
- Only the transmission fluid available as a replacement part may be used in the DSG transmission 0D9. Refer to the Parts Information.
- Using other fluids can cause malfunctions or transmission failure.
- The oil filler adapter must be clean and transmission fluid must not be mixed with another fluid!
-- Measure the length -a- of the vent pipe on the transmission fluid container and shorten it if necessary before installing the adapter for oil filling : VAS6262A . Refer to Measure the Length of the Bleed Pipe on the transmission fluid container. Shorten it if Necessary. .
-- Shake before opening.
-- Attach the transmission fluid container on the : VAS6262A .
-- Install the : VAS6262A into the opening for the drain and check plug -arrow 1- hand-tight.
-- Hold the container and : VAS6262A as high as possible over the transmission and fill the transmission with approximately 5.2 liters (5.5 qts) of transmission fluid.
-- Shift the selector lever in "P", push the parking brake button, in order to lock the electro-magnetic parking brake.
-- Press the brake pedal and hold it down.
-- Start engine and run at idle.
-- With brake pressed, shift through all selector lever positions "P, R, N, D/S" at idle, retaining each position for at least 3 seconds.
-- Move the selector lever into "P".
-- Check transmission fluid level. Refer to TRANSMISSION FLUID LEVEL, CHECKING .
Tightening Specifications
- Overview - Mechatronic. Refer to OVERVIEW - MECHATRONIC .