SUBFRAME Without Steering Gear, Removing And Installing: Notes
WARNING: This page is about a different variant/trim than selected.
Special Tools And Workshop Equipment Required
- Torque Wrench 1332 40-200 Nm :VAG1332
- Engine Support Bridge:10-222A
- Engine Support Supplement Set:T40093A , needed depending on the engine. The exact description for engine support. Refer To ENGINE, REMOVING AND INSTALLING [FOR ENGINE(S) CALA] , ENGINE, REMOVING AND INSTALLING [FOR TRANSMISSION(S) 0B6] [FOR ENGINE(S) CAUA] , and ENGINE, REMOVING AND INSTALLING [FOR ENGINE(S) CFSA] .
- Engine and Gearbox Jack:VAS6931
- Engine/Gearbox Jack Adapter - Wheel Hub Support:T10149
- Tensioning Strap:T10038
CAUTION:
This Procedure Contains Mandatory Replaceable Parts. Refer To Component Overview And Service Information Prior To Starting Procedure.
Mandatory Replacement Parts
The Following Tools Can Be Used On All Engine Versions. The Instructions For Each Engine Describe The Tools Needed For That Particular Engine. Refer To OVERVIEW - SUBFRAME MOUNT [FOR ENGINE(S) CALA] , OVERVIEW - SUBFRAME MOUNT [FOR TRANSMISSION(S) 0B6] [FOR ENGINE(S) CAUA] , and OVERVIEW - SUBFRAME MOUNT [FOR ENGINE(S) CFSA] .