Overview - SUBFRAME Mount
WARNING: This page is about a different car, the 2015 Audi RS 5, 2014 Audi RS 5, and 2013 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 20 Nm
- Retaining Plate
- For the engine mount
- If the engine mount is faulty, replace the retaining plate
- Check the retaining plate on the opposite side; replace if necessary
- Stop Buffer
- Not available individually
- Bolt
- 40 Nm
- Engine Support
- Bolt
- 10 Nm
- Heat Shield
- Not Installed
- Not Installed
- Bolt
- 90 Nm +90° turn
- Replacing
- Engine Mount
- Left with the Left Electrohydraulic Engine Mount Solenoid Valve -N144-
- Right with the Right Electrohydraulic Engine Mount Solenoid Valve -N145-
- Removing and installing: Left engine mount. Refer to LEFT ENGINE MOUNT, REMOVING AND INSTALLING , right engine mount. Refer to RIGHT ENGINE MOUNT, REMOVING AND INSTALLING
- Replace in pairs
- Subframe
- Bolt
- 55 Nm
- Bolt
- 55 Nm