Overview - SUBFRAME Mount
WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 20 Nm
- Retaining Plate
- For The Engine Mount
- If The Engine Mount Is Faulty, Replace The Retaining Plate
- Check The Retaining Plate On The Opposite Side; Replace If Necessary
- Stop Buffer
- Not Available Individually
- Bolt
- 40 Nm
- Engine Support
- Bolt
- 10 Nm
- Heat Shield
- Lower Left Coolant Pipe
- Bolt
- Tightening specification -item 26) OVERVIEW - COOLANT PIPES - Bolt .
- Bolt
- 90 Nm + 90° turn
- Always Replace
- Engine Mount
- With The Electro-Hydraulic Engine Mount Solenoid Valve
- Left Electrohydraulic Engine Mount Solenoid Valve -N144-, Right Electrohydraulic Engine Mount Solenoid Valve -N145-
- Removing and installing. Refer to LEFT ENGINE MOUNT, REMOVING AND INSTALLING . Refer to RIGHT ENGINE MOUNT, REMOVING AND INSTALLING
- Replace In Pairs
- Subframe
- Bolt
- 55 Nm
- Bolt
- 55 Nm