Overview - Bumper Cover, Except AUDI RS5
WARNING: This page is about a different variant/trim than selected.
- Trim Strip
- Audi S5 only
- Removing and installing. Refer to Installing => Trim Strip .
- Bolt
- 1.5 Nm
- Quantity: 9
- Bumper Cover Lower Section
- Removing and installing. Refer to ATTACHMENTS, REMOVING AND INSTALLING, EXCEPT AUDI RS5 => Lower Section .
- Bolt
- 1.5 Nm
- Quantity: 2
- Rear Bumper Cover
- Removing and installing. Refer to BUMPER COVER, REMOVING AND INSTALLING, EXCEPT AUDI RS5 .
- Left Rear Parking Aid Sensor -G203-
- Removing and Installing. Refer to Parking Aid .
- Bolt
- Quantity: 3
- Tightening sequence. Refer to Fig 2
- Side Mount
- For the bumper cover
- Removing and installing. Refer to BUMPER GUIDE PIECES, REMOVING AND INSTALLING => Side Mount .
- Clip nut
- Quantity: 3
- Bumper Cover Locking Mechanism
- Clamping screw tightening specification 2.5 Nm.
- Removing and installing. Refer to Installing => Retainer .
- Clip nut
- Quantity: 2
- Bolt
- Quantity: 2
- Tightening sequence. Refer to Fig 2
- Nut
- 4 Nm
- Left Rear Center Parking Aid Sensor -G204-
- Removing and Installing. Refer to Parking Aid .
- Right Rear Center Parking Aid Sensor -G205-
- Removing and Installing. Refer to Parking Aid .
- Nut
- 4 Nm
- Right Rear Parking Aid Sensor -G206-
- Removing and installing. Refer to Parking Aid .
- Cap
- For the towing eye
- Bolt
- 1.5 Nm
- Quantity: 3
Side Mount and Bumper Cover Locking Mechanism - Tightening Specifications and Sequence
-- Tighten the bolts to 1.5 Nm in the following sequence: -1 to 5- .