Attachments, Removing And Installing, Except AUDI RS5: Installing
WARNING: This page is about a different variant/trim than selected.
- Tightening specification. Refer to OVERVIEW - BUMPER COVER, EXCEPT AUDI RS5 .
Install in reverse order of removal. Note the following:
-- When pressing on, make sure the end points are guided into the bumper cover before pressing on for the final time.
Trim Strip
Removing
-- Remove the lower section of the bumper cover. Refer to ATTACHMENTS, REMOVING AND INSTALLING, EXCEPT AUDI RS5 => Lower Section .
-- Remove the bolts -arrows- .
-- Remove the trim molding -1- forward from lower section of the bumper cover -2- .
Installing
- Tightening specification. Refer to OVERVIEW - BUMPER COVER, EXCEPT AUDI RS5 .
Install in reverse order of removal. Note the following:
-- Install the lower section of the bumper cover. Refer to ATTACHMENTS, REMOVING AND INSTALLING, EXCEPT AUDI RS5 => Lower Section .