Component Location Overview - Hydraulic Power Steering, Vehicles With 6-Cylinder Diesel Engine, Vehicles With And Without Dynamic Steering

WARNING: This page is about a different variant/trim than selected.

Line And Hose Securing Elements, Assembly Overview

Fig 1: Lines And Hoses Overview (6-Cylinder FSI Engine)

Courtesy of AUDI OF AMERICA, LLC

Reservoir bracket to body. Refer to Fig 2
Reservoir in bracket. Refer to Fig 3
Bolt in bracket. Refer to Fig 2
Hydraulic oil cooler to condenser. Refer to Fig 5
Power steering pump in the bracket. Refer to OVERVIEW - POWER STEERING PUMP, VEHICLES WITH 6-CYLINDER DIESEL ENGINE, VEHICLES WITH DYNAMIC STEERING or OVERVIEW - POWER STEERING PUMP, VEHICLES WITH 6-CYLINDER DIESEL ENGINE, VEHICLES WITHOUT DYNAMIC STEERING .
Pressurized line to crossbrace. Refer to Fig 6
Pressure line connection installation location. Refer to Fig 6
Pressurized line to the engine mount. Refer to Fig 7
Return line to the subframe. Refer to Fig 9
Return line bracket to the subframe. Refer to Fig 8 and longitudinal member. Refer to Fig 4

Reservoir Bracket To The Body

Fig 2: Identifying Reservoir Bracket To Body

Courtesy of AUDI OF AMERICA, LLC

-- Secure the bracket -2- to the body with bolts -1-.

-- Secure the reservoir -4- in the bracket -2- using the bolt -3-.

Reservoir In The Bracket

Fig 3: Identifying Reservoir In Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Insert the reservoir with the tab -1- in the opening in the bracket -2-.

Line Bracket for Lines to the Longitudinal Member

Fig 4: Line Bracket for Lines to the Longitudinal Member

Courtesy of AUDI OF AMERICA, LLC

-- Secure the return line -1- with the pressure tube -2- and nuts -3- on the left longitudinal member.

-- Secure the return hose -5- with the clamp -4- on the return line -1-. Note the installation position -arrows-. Refer to HOSE LINES TO RESERVOIR, HYDRAULIC FLUID COOLER AND RETURN LINE INSTALLED POSITION .

Hydraulic Oil Cooler To Condenser

Fig 5: Hydraulic Oil Cooler To Condenser

Courtesy of AUDI OF AMERICA, LLC

-- Position the hydraulic oil cooler -1- on the brackets -2- and then engage it into the brackets -3-.

Pressurized Line To Crossbrace

Fig 6: Identifying Pressurized Line To Crossbrace

Courtesy of AUDI OF AMERICA, LLC

-- Install the pressure line on the crossbrace using the nut -3- and rubber bushing -4-.

-- Note the line installation location when bolting the line connection. The markings -1- and -2- must be opposite each other.

Pressurized Line To The Engine Mount

Fig 7: Identifying Pressurized Line To Engine Mount

Courtesy of AUDI OF AMERICA, LLC

-- Route the pressure line -4- between the connector -2- and the engine mount -3-.

-- Tighten the retaining bracket -5- on the threaded pin -1- using the nut -6-.

Return Line Bracket To The Subframe

Fig 8: Identifying Return Line Bracket To Subframe

Courtesy of AUDI OF AMERICA, LLC

-- Secure the return line with the wiring bracket -1- to the left front of the subframe -2-.

Pressure And Return Line To The Subframe

Fig 9: Identifying Return Line To Subframe

Courtesy of AUDI OF AMERICA, LLC

-- Install the return line -4- on the subframe -3- using the bracket -2- and bolt -1-.