Overview - Power Steering Pump, Vehicles With 6-Cylinder Diesel Engine, Vehicles Without Dynamic Steering

WARNING: This page is about a different variant/trim than selected.

Power Steering Pump, Removing and Installing, 6-Cylinder Diesel Engine, Vehicles without Dynamic Steering. Refer to POWER STEERING PUMP, REMOVING AND INSTALLING, 6-CYLINDER DIESEL ENGINE, VEHICLES WITHOUT DYNAMIC STEERING .

Power Steering Pump Assembly Overview

NOTE:

Always Replace Seals.

Do Not Reuse Fluid You Have Drained.

Only Use Hydraulic Fluid.

Fig 1: Overview Of Power Steering Pump, Vehicles Without Dynamic Steering With 6-Cylinder Engine

Courtesy of AUDI OF AMERICA, LLC

Bracket
Sleeve
- Drive The Sleeve Back Slightly To Install The Power Steering Pump.
Bolt
- 25 Nm
Bolt
- 9 Nm
Seal
- Always replace if removed
Pressure Line
CAUTION:
- Insert the pressure line completely when installing.
- Depending on the version, also mounted to the A/C compressor
Intake Hose
- The "P" marking on the evacuation hose -arrow- must align with the formed seam -arrow- on the power steering pump.
Clamp
- Tension using Hose Clip Pliers:VAG1275A
- Always replace if removed
Bolt
- 22 Nm
Belt Pulley
Power Steering Pump
- Allocation. Refer to the Parts Information..
- Fill with Hydraulic Fluid before installing
- Delivery pressure, checking. Refer to POWER STEERING PUMP, CHECKING DELIVERY PRESSURE, 6-CYLINDER DIESEL ENGINE, VEHICLES WITH AND WITHOUT DYNAMIC STEERING .
- Removing and installing. Refer to POWER STEERING PUMP, REMOVING AND INSTALLING, 6-CYLINDER DIESEL ENGINE, VEHICLES WITHOUT DYNAMIC STEERING .
- Bleed the steering. Refer to STEERING, BLEEDING AFTER REPLACING .
- Check hydraulic fluid level. Refer to POWER STEERING FLUID LEVEL, CHECKING .
- Steering System, checking for leaks. Refer to STEERING, CHECKING FOR LEAKS .
Bolt
- 25 Nm