Starter, Removing And Installing, Vehicles With 3.0L TFSI And 3.2L FSI Engine: Installing

Fig 1: Identifying Seal -1- And Opening For Starter -2- -Arrow-

Courtesy of AUDI OF AMERICA, LLC

• Tightening Specifications. Refer To OVERVIEW - STARTER .

Install In Reverse Order Of Removal. Note The Following: 

-- If The Vehicle Has A Multitronic Transmission, Make Sure The Seal -1- Fits Correctly Inside The Starter Opening Before Installing The Starter.

• The Sealing Piece Must Cover The Opening For The Starter -2- -arrow-.

-- Install The Engine Support And The Right Engine Mount. Refer To RIGHT ENGINE MOUNT, REMOVING AND INSTALLING [FOR TRANSMISSION(S) 0B6] [FOR ENGINE(S) CAUA] .

With Manual/Multitronic Transmission:

-- Install The Right Catalytic Converter. Refer To The Appropriate Service Information CATALYTIC CONVERTER, REMOVING AND INSTALLING - [FOR ENGINE CODES : CABB, CABA, CABD, CAEA, CAEB, CDHB, CDNB, CDNC, CDHA, CDZA, CADA, CCUA, CFKA, CPMA, CAED, CPMB] , CATALYTIC CONVERTER, REMOVING AND INSTALLING [FOR ENGINE(S) CAED, CAEB, CPMB, CPMA] , EMISSIONS CONTROL [FOR ENGINE(S) CALA] , CATALYTIC CONVERTER, REMOVING AND INSTALLING [FOR TRANSMISSION(S) 0B6] [FOR ENGINE(S) CAUA] .

-- Install The Right Front Muffler. Refer To EXHAUST PIPES/MUFFLERS, DISCONNECTING [FOR ENGINE(S) CAED, CAEB, CPMB, CPMA] , FRONT MUFFLER, REMOVING AND INSTALLING [FOR TRANSMISSION(S) 0B6] [FOR ENGINE(S) CAUA] , FRONT MUFFLER, REMOVING AND INSTALLING [FOR ENGINE(S) CAED, CAEB, CPMB, CPMA] and FRONT MUFFLER, REMOVING AND INSTALLING [FOR ENGINE(S) CALA] .

-- Install The Plenum Chamber Bulkhead. Refer To PLENUM CHAMBER COVER, REMOVING AND INSTALLING / OVERVIEW - PLENUM CHAMBER BULKHEAD .

Continuation For All Vehicles:

-- Connect The Battery. Required Actions. Refer To CONNECTING .