Battery, Disconnecting And Connecting: Connecting
WARNING: This page is about a different variant/trim than selected.
- Tightening Specification: COUPE : Refer To OVERVIEW - BATTERY, COUPE ; SPORTBACK : Refer To OVERVIEW - BATTERY, SPORTBACK .
-- Disconnect The Connector -2- From The Battery Monitoring Control Module -J367- -Item 1-.
-- Connect The Ground Wire Terminal Clamp -3- By Hand To The Battery Negative Terminal - - - And Tighten The Nut.
-- Reconnect The Connector To The Battery Monitoring Control Module -J367-.
-- Install The Vehicle Tool Kit Cover. Refer To OVERVIEW - LUGGAGE COMPARTMENT FLOOR .
When The Battery Is Reconnected, The Following Steps Must Be Performed:
- Activate The One-Touch Up/One-Touch Down Power Window Regulators. Refer To The Owner's Manual.
- Check DTC Memories Of All Control Modules And Erase "Undervoltage" DTC If Necessary. Refer To Vehicle Diagnostic Tester.
NOTE:
After Reconnecting The Power Supply, The ESP Warning Lamp Can Only Go Out After The Vehicle Has Been Driven A Few Meters.