Section 11 (Controls, Housing - Manual Transmission Internal Components 0B2 AWD (Coupe))

• 34 Controls, Housing
  • Description And Operation
    • Transmission Overview
    • Transmission And Differential Housing Assembly Overview
    • Center Differential Housing And Center Differential Assembly Overview
    • Left Flange Shaft, Clutch Module, Side Shaft, Gearshift Shaft And Transmission Cover Assembly Overview
    • Input Shaft, Output Shaft, Reverse Drive Gear And Shift Rails/Shift Forks Assembly Overview
      • Notes
      • Reverse Drive Gear Assembly Overview
  • Specifications
    • Fastener Tightening Specifications
  • Disassembly And Assembly
    • Transmission, Assembly Sequence
      • Notes
      • Transmission, Disassembling
      • Transmission, Assembling.
        • Notes
        • Determine The Locking Ring -Arrow- For The Input Shaft As Follows:
        • Install The Gear Carrier On The Transmission Cover As Follows:
    • Center Differential Housing
      • Notes
      • Installing The Flange Shaft Ball Bearing And Spacer Sleeve
      • Removing The Flange Shaft Ball Bearing And Spacer Sleeve
      • Remove The CIRCLIP -Arrow-.
      • Prying Out The Shaft Seal -1-
      • Installing The Seal For The Rear Flange Shaft
      • Pressing Out Flange Shaft
      • Pressing In Flange Shaft
    • Transmission Cover
      • Notes
      • Removing And Installing The Large Locking Bushing -1- On The Gearshift Shaft
      • Installed Dimension For The Large Locking Bushing -1- Inside The Transmission Cover
      • Installing The Needle Bearing All The Way Into The Transmission Cover
      • Securing The Needle Bearing Inside The Transmission Cover By PEENING It
      • Pressing Tapered Roller Bearing Outer Race Out From The Transmission Cover
      • Installing The Outer Race / Tapered Roller Bearing All Way Into The Transmission Cover
      • Removing The Input Shaft Roller Sleeve From The Transmission Cover
      • Installing The Input Shaft Roller Sleeve -A- All The Way Into The Transmission Cover
      • Removing And Installing The Gearshift Shaft Cover -A-
      • Gearshift Shaft Cover Assembly Overview
      • Assembly Overview - Gearshift Shaft Cover With A Hole -Arrow- For The Transmission Neutral Position Sensor -G701- Or Cap
      • Gearshift Shaft Seal, Removing And Installing
      • Removing The Gearshift Shaft Ball Sleeve From The Cover
      • Installing The Gearshift Shaft Ball Sleeve -A- Evenly In The Cover -B-
      • Installing The Gearshift Shaft Ball Sleeve -A- Up To Dimension -X- Into The Cover -B-,
      • Removing The Bearing Bushing For The 3RD And 4TH Gear Gearshift Rail /. From The Transmission Cover
      • Installing The Bearing Bushing -A- For The 3RD And 4TH Gear Gearshift Rail / Shift Fork All The Way Into The Transmission Cover
    • Transmission Housing
      • Notes
      • Breather Pipe Installation Dimension
      • Removing The Bearing Bushing For The Gearshift Rail / Shift Fork
      • Installing The Bearing Bushing -Arrow- For The Gearshift Rail / Shift Fork
      • Removing The Output Shaft Ball Bearing From The Transmission Housing
      • Installing The Output Shaft Ball Bearing -A- In The Transmission Housing
      • Installing The Input Shaft Ball Bearing -A- In The Transmission Housing
      • Installed Position: Locking Rings -A- For The Ball Bearings -B-
    • Gearshift Rails And Selector Forks
      • Notes
      • Gearshift Rails / Shift Forks Installed Positions Inside The Transmission.
  • Special Tools