Overview - Reducing Agent Delivery Module
WARNING: This page is about a different car, the 2016 Audi Q5, 2015 Audi Q5, and 2014 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Reducing Agent Tank
- Seal
- Replace
- Install dry
- Heating Reservoir
- With the Reducing Agent Pump -V437-
- With Reducing Agent Tank Sensor -G684-
- With Reducing Agent Temperature Sensor -G685-
- With Reducing Agent Tank Heater (Heating Circuit 1) -Z102-
- With filter
- Removing and installing, refer to REDUCING AGENT DELIVERY MODULE, REMOVING AND INSTALLING .
- Union Nut
- Use Key T40283 to remove and install
- Tightening, refer to Installing - "Install the union nut -2- so that the marking -3- lines up at the beginning of the first thread -4-. The arrow marking -1- on the tank is found here" (See Figure).
- Reducing Agent Line
- To Reducing Agent Injector -N474-
- Disconnect the wires for the reducing agent, refer to REDUCING AGENT DELIVERY LINE, REMOVING AND INSTALLING .
- Connector