Fan Shroud, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

The hose connections as well as the air guide pipes and hoses must be free of oil and grease before installing.

Secure all hose connections with hose clamps of the same type as those equipped by the factory .

-- Install the impact member, refer to IMPACT MEMBER, REMOVING AND INSTALLING .

-- Install the ATF lines, refer to ATF CIRCUIT for 0BW, ATF CIRCUIT for 0BK, or ATF CIRCUIT for 0B6 .

-- Connect the coolant hoses with the connector coupling, refer to Figure.

NOTE:

Do not reuse used coolant.

-- Fill the coolant pump, refer to Filling for Non-Hybrid Vehicles, or Filling for Hybrid Vehicles.

-- Check the ATF level, refer to ATF LEVEL, CHECKING for 0BW, ATF LEVEL, CHECKING for 0BK, or ATF LEVEL, CHECKING for 0B6 .