LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 644 (3.0L - Diesel Fuel Injection - Engine Code(S): CPNB (As Of 07.2014)) >> 23 Diesel Fuel Injection >> Intake Manifold >> Intake Manifold, Removing And Installing >> Installing

Intake Manifold, Removing And Installing: Installing

WARNING: This page is about a different car, the 2016 Audi Q5, 2015 Audi Q5, and 2014 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the seals

The hose connections as well as the air guide pipes and hoses must be free of oil and grease before installing.

Secure all hose connections with hose clamps of the same type as those equipped by the factory .

To mount the air guide hoses on their connectors securely, spray the bolts on the used clamps with rust remover before installing.

-- Tighten the intake manifold bolts, refer to Figure.

-- Install the high pressure line, refer to HIGH PRESSURE LINES, REMOVING AND INSTALLING .

-- Install oil dipstick guide tube, refer to OVERVIEW - OIL PAN/OIL PUMP, OIL PAN UPPER SECTION .

-- Install the EGR pipe, refer to OVERVIEW - EXHAUST GAS RECIRCULATION .

scientia non olet · About LEMON Manuals