Overview - Oil Pan/Oil Pump, Oil Pan Upper Section
WARNING: This page is about a different car, the 2016 Audi Q5, 2015 Audi Q5, and 2014 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 9 Nm
- Oil Pressure Regulation Valve -N428-
- Removing and installing, refer to Oil Pressure Regulation Valve -N428-, REMOVING AND INSTALLING .
- O-Ring
- Replace
- Oil Pan Upper Section
- Removing and installing, refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .
- Seal
- Replace
- Alignment Sleeve
- Guide Tube
- For the oil dipstick
- Bolts
- 9 Nm
- O-Rings
- Replace
- Plug
- Seal
- Replace
- Oil Return Valve
- For the engine oil cooler
- Seal
- Replace
- Alignment Sleeve
- Bolt
- Tightening specification and sequence, refer to Fig 2.
- Seal
- Replace
- Sealing Plug
- 25 Nm
- For Top Dead Center (TDC) marking
- Vacuum Line
- From the vacuum pump
- Bolt
- 3 Nm + an additional 45° turn
- Replace
- O-Ring
- Replace
- Bolt
- 9 Nm
NOTE:
Replace any bolts that were tightened with an additional turn.
-- Tighten the bolts in three steps and in the sequence shown:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 to 12- | 2 Nm |
| 2. | -1 to 12- | 5 Nm |
| 3. | -1 to 12- | Tighten an additional 90° |