Overview - Drive Plate
WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For the assembly work, secure engine with Engine/Transmission Holder - V6 FSI Bracket VAS6095/1-5 to Engine and Transmission Holder VAS6095, refer to ENGINE, SECURING ON ENGINE AND TRANSMISSION HOLDER .
- Drive Plate
- With the bearing flange
- Check the running surfaces on the bearing flange and the clutch module holes or torque converter for cracks and signs of wear.
- Removing and installing, refer to DRIVE PLATE, REMOVING AND INSTALLING .
- Bolt
- 60 Nm + 90° turn
- Replace
- Needle Bearing
- Not for vehicles with DSG transmission 0B5 or automatic transmission 0B6
- Pressing out, refer to NEEDLE BEARING IN DRIVE PLATE, REPLACING
- Sensor Wheel
- For Engine Speed Sensor -G28-
- Crankshaft
- Alignment Pin
- Crankshaft Shaft Seal, Transmission Side
- Replacing, refer to CRANKSHAFT SEAL, REPLACING, TRANSMISSION SIDE .