Crankshaft Seal, Replacing, Transmission Side

WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Seal Installer - Crankshaft T10122A
Puller - Crankshaft/Power Steering Seal T20143/2

Procedure

Fig 1: Prying Out Sealing Ring Using Extractor Lever T20143/2

Courtesy of AUDI OF AMERICA, LLC

The transmission is removed.

-- Remove the drive plate, refer to DRIVE PLATE, REMOVING AND INSTALLING .

-- Pry out the shaft seal using Puller - Crankshaft/Power Steering Seal T20143/2.

-- Clean the running and sealing surface.

-- Place the Assembly Device T10122/1 on the Pull Sleeve T10122/2 and slide the shaft seal -A- onto the pull sleeve.

Fig 2: Identifying Seal, Sleeve T10122/1 And Assembly Tool T10122/2

Courtesy of AUDI OF AMERICA, LLC

-- Remove the assembly aid.

-- Position the Pull Sleeve T10122/2 with shaft seal -1- on the crankshaft.

Fig 3: Installing Pull Sleeve T10122/2 With Sealing Ring Onto Crankshaft

Courtesy of AUDI OF AMERICA, LLC

-- Press shaft seal in evenly all around with Thrust Piece T10122/3 until flush.

Fig 4: Pressing In Seal Using T10122/3

Courtesy of AUDI OF AMERICA, LLC

-- Install the drive plate, refer to DRIVE PLATE, REMOVING AND INSTALLING .