LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 639 (3.2L - Crankshaft & Cylinder Block - Engine Code(S): CALB) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Transmission Side >> Drive Plate, Removing And Installing >> Installing

Drive Plate, Removing And Installing: Installing

WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the drive plate bolts.

The drive plate in the vehicles with DSG transmission 0B5 or automatic transmission 0B6 must not have any needle bearings. Check if a needle bearing is inserted before installing. Remove the needle bearing in the drive plate, refer to NEEDLE BEARING IN DRIVE PLATE, REPLACING .

-- Be careful of the alignment bushings during installation.

-- Turn the Counterhold - Flywheel 10-201 over to tighten the bolts.

scientia non olet · About LEMON Manuals