Overview - Seat Bench/Single Seat

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

In the illustration is 2/3 left rear seat is shown.

Fig 1: Overview Of Seat Bench/Single Seat (2/3 Left Rear Seat Is Shown)

Courtesy of AUDI OF AMERICA, LLC

Mounting Grommet
- Quantity: 2
- For securing bench seat
- Clipped into the seat frame
  CAUTION:
  The mounting grommets must be replaced each time the bench seat is removed.
- Removing and installing. Refer to INSTALLING - "Remove the mountings -5- from the seat frame ".
Bench Seat
- Removing and installing. Refer to SEAT BENCH/SINGLE SEAT, REMOVING AND INSTALLING .
Cover
- For the seat rail
- Vehicle equipment level or depending on the version
- Removing with the seat removed, refer to Fig 2
Bolt
- 50 Nm
- Quantity: 4
- Tightening sequence, refer to INSTALLING .
Rear Seat
- Removing and installing. Refer to REAR SEAT, REMOVING AND INSTALLING .
Cover
- For the LATCH child seat anchorage
- Equipment levels
- Quantity: 2
- Clipped to the LATCH child seat anchorage brackets that are welded to the seat frame

Fig 2: Identifying Seat Rail Cover

Courtesy of AUDI OF AMERICA, LLC

-- Remove the seat rail cover -arrow-.