Seat Bench/Single Seat, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Bench Seat From Vehicle

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Replace the mounting grommets each time the bench seat is removed.

-- Remove the mountings -5- from the seat frame .

-- Check the seat frame near the mounting plates for any deformation, and align it, if necessary.

-- Press the mounting plates onto the seat frame until you hear them click into place.

Install in reverse order of removal. Note the following:

-- Install the seat bench while installing the rear wire hook -3- under the seat frame -2- -arrow-.

-- Press the front wire hook -4- into the mounting -5- on the seat frame until it audibly engages.

NOTE:

Make sure the seat heating electrical collections slide on and engage audibly.