Dual-mass flywheel, removing and installing: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 Audi S4, 2008 Audi S4, 2007 Audi S4, 2006 Audi S4, and 2005 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in reverse order of removal, note the following:

NOTE:

Needle bearing is located in the flywheel and must be driven in when flywheel is replaced → Dual-mass flywheel needle bearings, pulling out and driving in .

Use new bolts when securing.
Turn over counterhold tool 10-201 to tighten bolts.
Install clutch pressure plate → 30 CLUTCH .