Dual-mass flywheel needle bearings, pulling out and driving in

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 Audi S4, 2008 Audi S4, 2007 Audi S4, 2006 Audi S4, and 2005 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools, testers and auxiliary items required

Fig 1: Bearing Driver 3264

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Bearing driver 3264

Fig 2: Kukko 21/2 Internal puller, Kukko 21/4 Internal puller, Kukko 22/2 Counter support

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - Internal puller Kukko 21/1
4 - Counter-support Kukko 22/1

Work procedure

Transmission removed.

Remove clutch pressure plate → 30 CLUTCH .

Fig 3: Pulling Out Needle Bearing Using Internal Puller Kukko 21/1 And Support Kukko 22/1

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Pull out needle bearing using internal puller Kukko 21/1 and support Kukko 22/1.

Fig 4: Driving In Needle Bearing Using Bearing Driver 3264 Into Dual-Mass Flywheel Until It Reaches Stop

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Drive in needle bearing using bearing driver 3264 into dual-mass flywheel until it reaches stop.
Install clutch pressure plate → 30 CLUTCH .