Microswitch for headrest, assembly overview
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
1 - Cable tie
2 - Connector
3 - Circlip
4 - Microswitch for headrest
- Removing
- Remove backrest panel → Backrest cover panel, removing and installing .
- Use a screwdriver to pry out circlip - 3 -.
- Press together catches - 5 - (2x) and remove microswitch - 4 -.
- Disconnect connector - 2 -.
- Installing
- Press in microswitch - 4 - until the catches - 5 - (2x) engage.
- Connect connector - 2 -.
- Install seat → Seat, assembly overview .
- Adjust microswitch for headrest → Microswitch for headrest, adjusting .
- Insert the circlip - 3 -.
- Install backrest panel → Backrest cover panel, removing and installing .
5 - Catches (2x)