Rear lid, removing and installing: Notes
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
1 - Rear lid
- Removing:
- Remove warning triangle with bracket - 5 -
- Remove rear lid lining.
- Disconnect electrical harness connectors and pull out of lid.
- Remove the nuts that connect both lid hinges to rear lid.
- Second technician is needed to support and lift hood during removal.
- Installing:
- Install in reverse order of removal.
2 - Buffer stop
- Adjusting → Adjusting buffer stops
3 - Expanding nut
4 - Bolt
5 - Bracket
6 - Striker
- Removing and installing Striker, removing and installing
- Adjusting Adjusting rear lid
7 - Nut
- 8 Nm