Adjusting rear lid
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
- Remove trim for rear panel. →
- 70 - INTERIOR TRIM
- 70 - INTERIOR TRIM for BODY INTERIOR - CABRIOLET
NOTE:
- The gas-filled struts must be attached before installing a new rear lid.
- Loosen nuts - 1 - , striker - 2 - must be able to be moved.
- Carefully close rear lid until lid is flush with side panels.
- Carefully open lid and tighten nuts - 1 - to 8 Nm.