Carry out ATF flush test run

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2009 Audi A4, 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

ATF filled → ATF, filling for ATF flushing process .
The input shaft (air gap) adjustment is OK → Input shaft adjustment (air gap), checking

Drive vehicle off hoist.

NOTE:

On vehicles with air suspension, vehicle lifting mode must be deactivated → 43 - SELF-LEVELING SUSPENSION .

CAUTION: Do not allow engine to run without filling ATF and do not tow the vehicle.

Follow specifications exactly and carry out all safety instructions.

CAUTION: In following test drive, all traffic laws must be followed. If necessary, vehicle must be driven on a test site.

Start engine.
Place selector lever in position "D".
Shift selector lever into "Tiptronic gate".
Move wheels by lightly pressing accelerator.

Note driving mode display in instrument cluster
Move from 1st to highest gear by moving selector level towards "+".
Then move back to 1st gear by moving selector lever back towards "-".

NOTE:

Press brake pedal if necessary

Press brake pedal and brake wheels down to 0 km/h.
Place selector lever in position "R".
Accelerate wheels up to 20 km/h by lightly pressing accelerator.
Press brake pedal and brake wheels down to 0 km/h.

Place selector lever in position "D" again and repeat same procedure 5 times.

NOTE:

Process must be repeated five times so that all old ATF is mixed with new ATF.

Place selector lever in position "P" afterwards and switch engine off.
Drain ATF → ATF, draining for ATF flushing process .
Fill with ATF → ATF, filling for ATF flushing process .
Carry out ATF flush ATF flush