Input shaft adjustment (air gap), checking
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2009 Audi A4, 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Do not allow engine to run without filling ATF and do not tow the vehicle.
- ATF filled
- Drive vehicle off hoist.
NOTE:
- On vehicles with air suspension, vehicle lifting mode must be deactivated → 43 - SELF-LEVELING SUSPENSION .
- ATF filled
- Place vehicle on level surface.
NOTE:
- With parking brake released, vehicle may roll forward or backward by itself when in selector lever position "N".
- Start engine.
- Place selector lever in position "N".
- Do not engage parking brake.
- Do not operate brake pedal.
- Press accelerator.
- Vehicle should not be allowed to roll.
If vehicle rolls in selector lever position "N":
- Adjust selector lever cable → 37 - AUTOMATIC TRANSMISSION - CONTROLS, HOUSING
If selector lever cable adjustment is OK but vehicle still rolls in selector lever position "N":
- Input shaft, servicing → Input shaft, servicing with 6 lining discs or → Input shaft, servicing with 7 lining discs
NOTE:
- In this case, input shaft adjustment (air gap) was not performed correctly.
If vehicle does not roll in selector lever position "N" :
The input shaft adjustment with evaluation of air play is OK.
- Carry out ATF flush First test run pass through: under ATF flush