ATF, draining for ATF flushing process

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2009 Audi A4, 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Vehicle on a flat surface

NOTE:

Observe disposal regulations!
Activate vehicle lifting mode → 43 - SELF-LEVELING SUSPENSION before driving vehicle with air suspension onto hoist, that is, with all four wheels hanging.

Fig 1: Front And Rear Sound Insulation And Fasteners

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Loosen fasteners - 2 - and - 3 - and remove rear noise insulation - B -.
Place an oil receptacle underneath transmission.

Fig 2: Identifying ATF Check Plug

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove ATF drain plug - A - using triple square socket driver 3357 and drain ATF.
Tighten ATF drain plug again.

Tightening torque: 24 Nm.

CAUTION: Do not allow engine to run without filling ATF and do not tow the vehicle.