Ball bearing for input shaft and multi-function sensor, removing and installing: Notes

WARNING: This page is about a different car, the 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Transmission Housing, Input Shaft Ball Bearing And Multi-Function Sensor, Overview

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - Transmission housing

With differential and drive flanges
Removing and installing drive flanges. Refer to Oil seal for drive flange, replacing
Removing and installing differential. Refer to Differential, removing and installing
Removing and installing sensor and driving gear for speedometer. Refer to Speedometer vehicle speed sensor and drive-wheel, removing and installing

Installation position of bleeder valve. See Installation position of bleeder valve

2 - Internal TORX screw, 35 Nm

Self-locking
Replace

3 - Guide bushing

With O-ring and oil seal for input shaft. Refer to Clutch release mechanism components (on transmission), servicing

Fig 2: Transmission Housing, Input Shaft Ball Bearing And Multi-Function Sensor, Overview

Courtesy of VOLKSWAGEN UNITED STATES, INC.

4 - Dished washer

Small diameter (convex side) facing guide bushing

5 - Circlip

Defining thickness. Refer to Input shaft, adjusting

6 - Ball bearing

Removing and installing. Refer to Ball bearing for input shaft, multi-function sensor, pinion, selector rods, transmission cover and Torsen differential housing, removing and installing

7 - Circlip

Defining thickness. Refer to Input shaft, adjusting

8 - Input shaft

Removing and installing. Refer to Input shaft, pinion, hollow shaft, selector rods, transmission cover and Torsen differential housing, removing and installing
Disassembling and assembling. Refer to Input shaft, disassembling and assembling
Adjusting. Refer to Input shaft, adjusting
Servicing mounting for input shaft. Refer to Input shaft, disassembling and assembling

Fig 3: Transmission Housing, Input Shaft Ball Bearing And Multi-Function Sensor, Overview

Courtesy of VOLKSWAGEN UNITED STATES, INC.

9 - Bolt, 25 Nm

10 - Locking plate

For multi-function sensor

11 - Multi-function switch

12 - Connector

For multi-function switch

13 - Bolt, 10 Nm

14 - Cover for selector shaft

Removing and installing. Refer to Transmission shift mechanism, disassembling and assembling

15 - Locking unit for 5th gear and reverse gear

Removing and installing. Refer to Removing and installing locking unit for 5th gear and reverse gear