Shift lever knob and protective boot, removing and installing
WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
1 - Shift lever knob
- Remove and install together with protective boot
- Removing. Refer to Figure
2 - Protective boot
- Remove and install together with shift lever knob
- Removing. Refer to Figure
3 - Connector piece
- For locking shift lever knob to shift lever
- Opening catch. Refer to Figure
- Connects protective boot to shift lever knob
4 - Cover for center console
- Removing and installing. Refer to Figure
5 - Damping washer
- Installation position: Convex side upward
6 - Noise insulation
- Installation position: Arrow on noise insulation points in direction of travel
7 - Hex nut, 10 Nm
8 - Noise insulation
9 - Hex nut, 10 Nm
10 - Shift lever
- Removing and installing. Refer to Shift mechanism, removing and installing