Transmission Control Module, Removing And Installing: Installing

Install in reverse order of removal. At the same time note the following:

• Tightening specifications. Refer to OVERVIEW - END COVER .

-- If necessary, clean dirt and metal shavings off the sensors -5 through 8- and the connectors -1 through 3-.

Courtesy of AUDI OF AMERICA, LLC

-- Clean the selector shaft. Refer to SELECTOR SHAFT, CLEANING .

-- Before installing the Transmission Control Module -J217-, coat the new O-rings -A- on the hydraulic control module with ATF.

Courtesy of AUDI OF AMERICA, LLC

-- Install the Transmission Control Module -J217- without tilting it.

Courtesy of AUDI OF AMERICA, LLC

• The connectors on the back of the control module must lock securely into the terminals -A, B, and C- on the hydraulic control module.

-- Tighten the bolts -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- If equipped, mount the displacer -A- on the Transmission Control Module -J217-.

Courtesy of AUDI OF AMERICA, LLC

-- Install the end cover. Refer to END COVER, REMOVING AND INSTALLING .

-- Fill the ATF and check and correct the ATF level. Refer to ATF LEVEL, CHECKING .

-- Select the following menu options under Functions/Component selection  in Guided Fault Finding on the Vehicle Diagnostic Tester:

• Drivetrain 
• 0AW transmission 
• 01 OBD-capable systems 
• 02-Transmission electronics 
• 02-Transmission electronics, functions 
• 02-Replacing Control Module