Overview - End Cover
WARNING: This page is about a different car, the 2014 Audi A5, 2013 Audi A5, 2012 Audi A5, and 2011 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Risk of damaging the transmission.
- Do not let the engine run or tow the vehicle when the cover is removed or without filling ATF.
NOTE:
Refer to REPAIR INFORMATION .
Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
- Transmission
- Small Axial Sealing Element
- Always replace
- Large Axial Sealing Element
- Always replace
- Roller
- Lever
- For the selector lever lock mechanism
- Spring
- Seal
- For the connector on the Transmission Control Module -J217-
- Bolt
- 10 Nm +90°
- Always replace
- Quantity: 12, tighten diagonally
- Cover
- Removing and installing with the transmission installed. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .
- Refer to END COVER, REMOVING AND INSTALLING
- Seal
- Always replace
- Bolt
- 5 Nm + 90°
- Quantity: 3
- Transmission Control Module -J217-
- Bolt
- 5 Nm + 90°
- Quantity: 3
- Hydraulic Control Unit