Overview - Sealing Flange And Drive Plate

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Sealing Flange And Drive Plate

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Vibration Damper Bolts
- 60 Nm + 180° additional turn
- Always replace
- Quantity: 7
Vibration Damper
- Removing and installing. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .
Bolt
- 10 Nm
Sealing Flange
- Replacing. Refer to CRANKSHAFT SEALING FLANGE, REMOVING AND INSTALLING, VIBRATION DAMPER SIDE .
- With gasket
Cylinder Block
- Overview - crankshaft. Refer to OVERVIEW - CRANKSHAFT .
- Overview - piston and connecting rod. Refer to OVERVIEW - PISTON AND CONNECTING ROD
Sealing Flange
- Removing and installing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .
Seal
- Remove with the : T20143/2
- Do not oil or grease sealing lip of seal.
- Before installing, remove oil remains from crankshaft journal with a clean cloth
- Installing. Refer to SEAL, REMOVING AND INSTALLING, TRANSMISSION SIDE .
Shim
Bolt
- 60 Nm + 90° turn
- Always replace
- To loosen or tighten, use the : T10044 (with 5 mm spacers), or : T10069 .
Washer
Drive Plate
- Drive plate, removing and installing. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
Bolt
- 23 Nm