LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1164 (Engine Assembly [CAUA] (Coupe)) >> 10 Engine Assembly >> SUBFRAME Mount >> Engine Mount, Removing And Installing >> Left Engine Mount, Removing And Installing >> Installing

Left Engine Mount, Removing And Installing: Installing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal. Note The Following: 

NOTE:

Replace Any Bolts That Were Tightened With An Additional Turn.

When Installing, Bring All Cable Ties Back To Same Positions.

-- Align The Subframe And Using The Marks Made On Longitudinal Members During Removal.

-- Tighten The Subframe Bolts Only To The Tightening Specifications, Do Not Tighten Them Further (Tighten The Bolts Only After Axle Alignment). Refer To OVERVIEW - SUBFRAME .

WARNING:

Risk Of Accident Due To Loose Connections.

  • If The Bolts In The Subframe Are Not Tightened To Final Torque, Vehicle Must Not Be Driven.

-- Install The Stabilizer Bar. Refer To SUBFRAME, CROSSBRACE, DIAGONAL BRACE, STABILIZER BAR, COUPLING ROD AND SUBFRAME SHIELD OVERVIEW, FROM 09.2007 / OVERVIEW - SUBFRAME , And Install The Suspension Strut On The Control Arm. Refer To OVERVIEW - SUBFRAME .

-- Install The Electric Wires. Refer To The Appropriate Wiring Diagram(s).

-- Follow All Steps After Connecting The Battery. Refer To BATTERY, DISCONNECTING AND CONNECTING .

-- Attach The Steering Intermediate Shaft To The Steering Gear. Refer To STEERING INTERMEDIATE SHAFT, REMOVING AND INSTALLING / OVERVIEW - STEERING COLUMN .

-- Install The Power Steering Hydraulic Line. Refer To OVERVIEW - HYDRAULIC PIPES AND RESERVOIR .

-- Install The Lock Carrier Braces. Refer To LOCK CARRIER COVER, REMOVING AND INSTALLING .

-- Tighten The Left And Right Drive Axles On The Transmission Flange Shafts. Refer to OVERVIEW - FRONT AXLE .

-- Install The Wheel Housing Liners. Refer To WHEEL HOUSING LINER .

-- Install The Front Wheels. Refer To WHEEL, CHANGING AND MOUNTING .

-- Perform An Axle Alignment. Refer to AXLE ALIGNMENT INFORMATION / AXLE ALIGNMENT SPECIFIED VALUES / AXLE ALIGNMENT PROCEDURE .

WARNING:

Risk Of Accident Due To Loose Connections.

  • Tighten The Subframe Bolts To The Specification After Performing Axle Alignment.

-- Install the noise insulations. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals