LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 36 (Steering (Coupe)) >> 48 Steering >> Steering Column >> Overview - Steering Column

Overview - Steering Column

WARNING: This page is about a different variant/trim than selected.
Fig 1: Exploded View Of Steering Column
GWWA48-10503Courtesy of AUDI OF AMERICA, LLC
  1. Bolt
  2. Mounting Bracket
  3. Central Tube
  4. Bolt
    • 5 Nm 
  5. Electronic Steering Column Lock Control Module -J764-
    • Installed on vehicles with lock system
    • Removing and installing. Refer to ELECTRONIC STEERING COLUMN LOCK CONTROL MODULE -J764-, REMOVING AND INSTALLING .
    • If the Electronic Steering Column Lock Control Module -J764- was replaced, the following steps must be performed with the Vehicle Diagnostic Tester. To do so, select the appropriate program in "Guided Functions" and follow the instructions on the screen.
  6. Steering Column
    • Depending on the version of the steering (with or without dynamic steering) different versions of the steering columns are installed; refer to the Parts Information.
    • Actuator -arrow- installed on vehicles with dynamic steering.
    • The actuator -arrow- must not be loosened or separated from the steering column.
    • The actuator and the steering column are one component; they are replaced together. Refer to the Parts Information.
    • An "adjusting element for active steering (dynamic steering) safety lock" is installed on the actuator -arrow-.
    • Adjusting element for active steering (dynamic steering) safety lock. Refer to ACTIVE STEERING SAFETY LOCK ACTUATOR -F437-, REMOVING AND INSTALLING .
    • If the steering column and adjuster were replaced, then it is necessary to perform a basic setting on the dynamic steering. Refer to DYNAMIC STEERING BASIC SETTING .
    • Removing and installing. Refer to STEERING COLUMN, REMOVING AND INSTALLING .
    • Check for damage. Refer to STEERING COLUMN, CHECKING FOR DAMAGE .
  7. Right Knee Bar
    • Installed depending on the market
  8. Bolt
    • 20 Nm 
    • 22 Nm  on the Cabriolet
    • Depending on the market, the knee bar is bolted on the right driver side
    • Follow the assembly sequence when installing. Refer to Figure.
    • Quantity: 2
  9. Bolt
  10. Bolt
    • 20 Nm 
    • Follow the assembly sequence when installing. Refer to Figure.
    • Quantity: 2
  11. Bolt
    • 20 Nm 
    • Follow the assembly sequence when installing. Refer to Figure.
    • Quantity: 2
  12. Handle
  13. Bolt
    • 3 Nm 
  14. Bolt
    • 20 Nm 
    • Quantity: 2
    • Follow the assembly sequence when installing. Refer to Figure.
  15. Bolt
    • 30 Nm  +90°
    • Always replace if removed
    • The threaded hole for the bolt must always be cleaned (for example, using a thread tap).
  16. Sealing Boot
    • Align the positioning arrow to the "12 o'clock position".
  17. Steering Intermediate Shaft
  18. Bolt
    • 30 Nm  +90°
    • Always replace if removed
    • The threaded hole for the bolt must always be cleaned (for example, using a thread tap).
scientia non olet · About LEMON Manuals