LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (Engine Lubrication System (H4DOTC)) >> Oil Pump >> Removal

Oil Pump: Removal

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the collector cover.
  2. Disconnect the ground cable from battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G07679923Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the radiator. < refer to REMOVAL , Radiator.>
  4. Remove the crankshaft position sensor. < refer to REMOVAL , Crankshaft Position Sensor.>
  5. Remove the water pump. < refer to REMOVAL , Water Pump.>
  6. Remove the crank sprocket. < refer to REMOVAL , Crank Sprocket.>
    Fig 2: Removing Crank Sprocket
    G07679924Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the bolts which secure oil pump to cylinder block.
    NOTE: When disassembling and checking the oil pump, loosen the relief valve plug before removing the oil pump.
    Fig 3: Identifying Oil Pump And Relief Valve Plug
    G07679925Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the oil pump by using flat tip screwdriver.
    CAUTION: Be careful not to scratch the mating surface of the cylinder block and oil pump.
    Fig 4: Removing Oil Pump Using Flat Tip Screwdriver
    G07679926Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the front oil seal from the oil pump.
scientia non olet · About LEMON Manuals