Overview - Supercharger: Notes
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
- Engine Lifting Eye
- Bolt
- Tightening specification: 27 Nm
- Supercharger
- With charge air coolers
- Supercharger, Removing and Installing, refer to SUPERCHARGER, REMOVING AND INSTALLING .
- Charge Air Cooler Assembly Overview, refer to OVERVIEW - CHARGE AIR SYSTEM .
- Secure for work on the Engine And Transmission Holder VAS6095, refer to SUPERCHARGER, SECURING TO ENGINE/TRANSMISSION HOLDER FOR REPAIR WORK .
- Secure for leak test on the Engine And Transmission Holder VAS6095, refer to SUPERCHARGER, SECURING TO ENGINE/TRANSMISSION HOLDER FOR LEAKAGE TEST .
- Insulation Plate
- Bolt
- Tightening specification: 5 Nm
- Rubber Grommet
- Quantity: 2
- Intermediate Flange
- Bolt
- Tighten the bolts -arrows- to 10 Nm in a diagonal sequence.
- Throttle Valve Control Module -J338-
- Removing and installing, refer to Throttle Valve Control Module -J338-, REMOVING AND INSTALLING .
- O-Rings
- Replace
- Connection
- Bolt
- Tighten the bolts in three steps as follows: 1: 5 and 6, Install all the way in by hand. 2: 6, 10 Nm, 3: 5, 10 Nm.
- Bracket
- For change-over valves
- Bolt
- Tightening specification: 9 Nm
- Bolt
- Tighten the bolts in three steps as follows: 1: 5 and 6, Install all the way in by hand. 2: 6, 10 Nm, 3: 5, 10 Nm.
- Intermediate Flange
- Control Valve Control Unit -J808-
- Removing and installing, refer to Control Valve Control Unit -J808-, REMOVING AND INSTALLING .
- Bleed Screw
- Tightening specification: 1.5 to 3.0 Nm
- For the left charge air cooler
- Bolt
- 1: 5 and 6, Install all the way in by hand. 2: 6, 10 Nm, 3: 5, 10 Nm.
- Intake Air Temperature Sensor -G42-
- Removing and installing, refer to Intake Air Temperature Sensor -G42- /Manifold Absolute Pressure Sensor -G71-, REMOVING AND INSTALLING .
- O-Rings
- Replace
- Nut
- Tightening specification: 20 Nm
- O-Ring
- Replace
- Threaded Pin
- Tightening specification: 17 Nm
- Bolt
- Tightening specification: 10 Nm
- Replace
- Self-locking
- always clean the threaded holes with a thread tap before assembling
- Charge Air Pressure Sensor
- Cylinder bank 1 (right) Charge Air Pressure Sensor -G31-
- Cylinder bank 2 (left) Charge Air Pressure Sensor 2 -G447-
- Removing and installing, refer to CHARGE AIR PRESSURE SENSOR - G31 - / - G447 -, REMOVING AND INSTALLING .
- Seals
- Replace
- O-Ring
- Replace
- Quantity 2
- Connection
- For the crankcase ventilation
- Installed position, refer to Figure
- O-Ring
- Replace
- Quantity 2