Supercharger, Securing To Engine/Transmission Holder For Repair Work
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The openings on the bottom of the supercharger housing should make it possible to see and reach the charge air cooler.
Special tools and workshop equipment required
- Engine And Transmission Holder VAS6095
- Gearbox Support T40206
Procedure
- Supercharger removed, refer to SUPERCHARGER, REMOVING AND INSTALLING .
-- Install the Gearbox Support T40206 with T40206/1 in the Engine And Transmission Holder VAS6095.
-- Secure the supercharger to the transmission holder as illustrated. Use the holes "1", "4", "9", "11" and "13" for the threaded connectors -1-.
-- Attach the Gearbox Support Supplement T40206/2 directly to the compressor housing at the front and on the right side using the bolt -2-.
Installation position of the Gearbox Support Supplement T40206/2:
- The seals -arrow 1- on the support must face downward.
- It is possible to see and reach the charge air cooler through the openings -arrow 2- inside the supercharger housing.