Overview - VALVETRAIN: Notes
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Risk of damaging valves and piston heads after working on valve train.
- The motor must not be started for about 30 minutes after installing camshafts because the hydraulic equalization elements must seat themselves.
- To ensure valves do not strike pistons when starting, carefully rotate engine at least two full revolutions.
NOTE:
Cylinder heads with cracks between the valve seats, or between the valve seat and the spark plug threads, can continue to be used without reducing the service life, as long as the cracks have a width of max. 0.3 mm, or only the first 4 threads of the spark plug threads are cracked.
NOTE:
The cylinder head for cylinder bank 2 (left) is shown in the illustration.
- Sealing Plugs
- Install with sealant .
- Cylinder Head
- Valve guides, checking, refer to VALVE GUIDES, CHECKING .
- Valve Stem Seal
- Replacing with the cylinder head installed, refer to VALVE STEM SEALS WITH INSTALLED CYLINDER HEAD, REMOVING AND INSTALLING .
- Replacing with the cylinder head removed, refer to VALVE STEM SEALS WITH REMOVED CYLINDER HEAD, REMOVING AND INSTALLING .
- Valve Spring
- Installed position, refer to Fig 2
- Hydraulic Adjusting Element
- Clipped into roller rocker lever item -8-
- Checking, refer to HYDRAULIC ADJUSTING ELEMENTS, CHECKING .
- Mark the installed position for installation later
- Lubricate the running surfaces before installing
- Valve Spring Retainer
- Valve Keepers
- Roller Rocker Lever
- Mark the installed position for installation later
- Check roller for easy movement
- Lubricate the running surfaces before installing
- To assemble, clip onto the hydraulic adjusting element item -9- with securing clip item -5-
- Clip
- Not available individually
- Make sure it is secure
- Intake Camshaft
- Removing and installing, refer to CAMSHAFT, REMOVING AND INSTALLING .
- Axial Play, Measuring, refer to CAMSHAFT, MEASURING AXIAL CLEARANCE .
- Radial play, measuring, refer to CAMSHAFT, MEASURING RADIAL CLEARANCE .
- Maximum run out: 0.04 mm
- Bolt
- Replace
- Tightening specification and sequence, refer to Figure.
- Guide Frame
- With integrated camshaft bearings
- Removing and installing, refer to CAMSHAFT, REMOVING AND INSTALLING .
- Flat Ring
- Flat Ring
- Exhaust Camshaft
- Removing and installing, refer to CAMSHAFT, REMOVING AND INSTALLING .
- Axial Play, Measuring, refer to CAMSHAFT, MEASURING AXIAL CLEARANCE .
- Radial play, measuring, refer to CAMSHAFT, MEASURING RADIAL CLEARANCE .
- Maximum run out: 0.04 mm
- Oil Screen
- Intake Valve
- Do not rework, only grinding is permitted
- Mark the installed position for installation later
- Checking, refer to VALVES, CHECKING .
- Valve dimensions, refer to VALVE DIMENSIONS .
- Valve guides, checking, refer to VALVE GUIDES, CHECKING .
- Exhaust Valve
- Do not rework, only grinding is permitted
- Mark the installed position for installation later
- Checking, refer to VALVES, CHECKING .
- Valve dimensions, refer to VALVE DIMENSIONS .
- Valve guides, checking, refer to VALVE GUIDES, CHECKING .
- The tight spring coils -arrow- face toward the cylinder head.